STRAWBERRY HAIR CLIPS

Send

Hairpins with voluminous berries can easily decorate the girl's hairstyle in the summer season. And if you pick up another red or white dress for them, then there will be a sight for sore eyes.
To make a pair of hairpins, you must:
- red ribbon 5 cm wide cut 28 cm;
- green tape 3 cm wide 12 cm;
- rope with lurex 25 cm;
- the thread is yellow;
- a basis from felt of 2 pieces;
- satin ribbon width 2.5 white 1 m;
- yellow stamens 60 pcs;
- a cover seaming or another with a diameter of 7 cm;
- green tape with a width of 4 cm 50 cm;
- synthetic winterizer.
Berries
For one berry, you need a section of a red ribbon 7 cm long. We attach the lid and use a soldering iron or draw a contour with a pen. We need to get a semicircle, cut out and fix the edge over the fire.

Now we take a thread with a needle and short stitches, we sew through the entire surface of the workpiece, simulating seeds.

Now we fold the workpiece in half and sew one edge, you should get a cone with a hole at the base.

We turn the workpiece out and fill it with a synthetic winterizer. stitch along the upper edge with small stitches and tighten the part. A berry is formed.

Now with the help of a soldering iron we cut the sepals onto the eye.

You can cut it with scissors and fix all the slices, quickly passing through the flame of the candle.
Make a hole in the center of the sepal. We take a piece of rope intended for the stalk, thread it through the hole in the sepals and glue the rope in the middle of the berry. Now grease the top of the berry with glue and glue the sepals.

We do the rest 3 berries. Berries should be interconnected in pairs.
Leaflets.
For leaflets, cut pieces of 4 by 5 from a green satin ribbon, fold in half and cut an oval leaf in half.
Next, with scissors we form a leaf like that of the corresponding berry and fix it over the fire. Fold the leaf in half lengthwise, fix with tweezers and make a vein, then fold and make side veins.

Flowers.
For a flower, it is necessary to make round kanzashi petals from pieces of white ribbon 2.5 by 2.5 cm.

To do this, fold the square along the diagonal, then again in half, hold the fold and turn the corners in the opposite direction, hold with tweezers and fix the corner over the fire.

For each flower, 6 petals are needed, each flower has 3 flowers. As a result, the total number of petals is 36 pieces.
To assemble the flower, glue it at the corner of the leaflet, before gluing the extreme ones, insert a bundle of 10 stamens into the center and fix it with glue.

Barrette assembly.
Lubricate the felt circle with glue and glue the leaves with a fan.
Next, glue a bunch of 3 flowers and between them a twig with 2 berries.