Headband "Lisa"

To create a headband "Lisa" you need:
- finished headband made of blue knitwear.
- scissors.
- needle and thread for sewing.
- glue gun with interchangeable rods.
- large beads of silver color.
- decorative ornaments in the form of flowers of a lilac shade, with a diameter of 1 cm.
- round beads of blue hue.
- lighter.
- satin ribbon in blue and white.
Dressing sequence. From two types of ribbons, blue and white, we cut out segments equal to their width, so that as a result we get 5x5 cm details.
Then we wrap the upper right corner and apply it to the lower left, combining the edges. As a result, the part was folded in half and gave it the appearance of a triangle.
Then repeat the addition of the part.
Now we sell the thread in the eye of the needle and tie a knot at the end of the segment. We place the part in front of us, lowering the side with the slices down. We retreat 3 mm from the cuts and lay a stitch, evenly making stitches with a needle.
Without cutting the threads, tightly tighten the fabric and fasten in this state with several stitches.
Now cut off the edge of the thread and singe off the ribbon cuts. We straighten the part, evenly distributing the folds on the tape, and we get a petal with a pointed upper edge.
Following this sequence, create 9 more such petals for the main flower of the dressing. Having made them, put them aside and proceed to the creation of the remaining parts. Next we make milk petals from a white and blue ribbon. We cut both shades of tape with details with sides 5x5 cm. Then we make triangles from them, folding them in the center.
Then we fold in half twice more.
Then we repeat each action with a white square. We put the resulting blank into a blue triangle, fully combining their edges.
Now cut off the thin corners, carefully scorch the new cut, gluing together each addition of the ribbon.
We measure 1 cm along the fold lines and cut off the entire excess length of the tape. Then carefully burn the slices, protecting the fabric from shedding.
Expand the part and get such a petal.
For this dressing we create only 6 such details. Now bouts of preparing the petals for the middle of the flower. We will make it from a white ribbon, cutting a square with sides of 5 cm into 4 identical parts.
We double each such blank.
Then again we fold in half.
We take a lighter and carefully singe all available sections, while soldering the addition of ribbons together.
We create only 6 such squares. Then we combine them into a ring, slightly imposing one part on another, collecting together with hot glue.
Then in the center of this ring we attach a large bead of silver color, and around it we place one row of blue beads.
Proceed to join the decoration. Glue from the blue petals with a pointed top into two separate circles. For each ring we use 5 parts.
Now glue them one on top of the other, forming a flower.
In the center of the resulting flower, we attach the prepared middle of the white squares.
From the double parts we collect small twigs, combining them in three pieces together.
Now we place the created branches on a knitted dressing, leaving a distance between them of 5 cm.
The remaining void is closed with a blue flower.
It remains only to further decorate the bandage with beads and decorative flowers.
Bandage "Lisa" is ready!