DIY COMPUTER DESK

Send

Pretty simple and pretty design computer desk. Yes, of course, compared to the storefront, it is much cheaper and the design, if anything, can be changed as you like, for any interior.

Advantages of this computer corner:

The design is cheap and easy to manufacture.

You can set any height of the countertops.

great depth of the table. Previously used for CRT monitor handset.

there is where to stretch your legs (from the edge of the table to an angle of 80cm).

Very efficient use of room space - does not take up much space.

The countertop is made of a solid chipboard plate (600mm wide).

The corners are cut from the original rectangle and the resulting trapezoid is fastened with corners to the wall (blue circles).

The far corner of the table is cut out of the trim and placed on two washers screwed to the table top from below (green in the diagram) and a screw screwed into the wall (red). You can make a shelf from another trim.

A block of outlets is fixed under the tabletop.

and system specialist

Recently added to the table shelves made of laminated chipboard. Fortified in eight corners.

Stress testing of countertops - everything is fine, withstood calmly!

Load testing of a shelf of 42 kg:

Cost in total:

Worktop: 600x1600 ~ 700 rub

Corners for countertops: 4 pcs ~ 20 rub

Shelves: 20х100х3 + 20х130х3 + 25х15х4 ~ 350 rub

Tape for edging shelves: ~ 50 rubles

Screws and Euroscrews: ~ 50 rub

Corners for shelves: 100x125 ~ 10 pcs ~ 140 rubles

Total: Table and shelves: 750 + 600 = 1350 (with a margin)

PS: The systematic on the wall is the result of the fight against noise. The more massive the base, the less it resonates from the body. Therefore, hanging on the wall. Ideally, better on the main wall.

Send