Paper crocodile

Pin
Send
Share
Send

This animal is known for being among the highest category of reptiles. Crocodiles are even considered to be one of the closest relatives of extinct dinosaurs. A dangerous and toothy animal will not seem so scary if you try to make it out of paper.

For work, you need white and green sheets of paper, a pencil, scissors, a ruler, a black felt-tip pen, glue stick.

First, bend the green paper so that it turns out to be divided into 8 identical parts (this can be achieved by phasing in half folds).

We cut it according to the intended folds.

Six of the eight strips obtained are required to be bent in half.

Cut these strips.

One of the short strips must be cut lengthwise.

Now we start assembling our crocodile. His body will consist of 10 short wide stripes. We take one of them and apply a little glue to the edge.

Connect the strip to the ring and then insert the next green strip.

So we will continue until all ten strips are used. The body of the crocodile is ready.

Take a long, wide strip and insert it into the outermost ring.

Glue the ends of this long strip.

Make a diagonal incision. This will be the tail of the crocodile.

Insert another long strip from the other end.

Now take the remaining short wide strip and cut it along.

From one half we make the eyes of a crocodile. To do this, bend it in half and cut it in a semicircle from the edge.

Use glue to fix the eyes.

We will slightly correct the mouth of the crocodile. Cut the upper part along the edges, and bend it from the bottom.

We also make small bends on the front of the upper and lower jaw of the crocodile.

From the remaining two narrow and short stripes we will form the paws of the animal. Bend them along.

After that, we will make the folds so that the letter "P" is formed.

Using glue stick we fix the paws on the lower part of the body of the crocodile.

From white paper we cut a strip 1.5 cm wide.

Cut two circles from its edge. These will be the eyes of the animal.

Glue them.

On the remaining part of the white strip, draw the teeth with a black felt-tip pen.

Insert this strip into the mouth of the crocodile and fix it with glue.

It remains to finish the details - we take a black felt-tip pen and paint on the pupils and claws of the animal.

Our paper crocodile is ready.

Pin
Send
Share
Send

Watch the video: Kids Art and Craft: How to make 3D paper crocodile (December 2024).